Table of Contents
Advertisement
Internal cleaning
In the RM5HD electronic coin validator the coin recognizing sensors are installed behind a small spring
door. Open the door to have access to this space as shown (fig.1).
Clean the excess dirt from behind the door with a grease removing spray, for example a normal
detergent for windows and mirrors, removing more resistant dirt with a small brush.
Ethyl alcohol can be used. Do not touch or spray the sensors!
There are three small holes behind the door. These holes are where the coin recognizing sensors are
put in place (fig.2). If dust or dirt blocks these holes the performance of the coin validator could be
reduced and, in extreme cases, no coins would be recognized.
To keep the sensors clean, whilst in position use compressed air only.
Fig.1
Fig.2
ATTENTION:
Do not use any type of sharp object, such as pins or screw drivers, to remove dust from
the sensors as they could be irreparably damaged putting the coin validator out of use.
If the coin validator is still inefficient after cleaning do not hesitate to contact our hotline.
Manual Go4Platin_en COMPLETE.docx / BG
14
Advertisement
Table of Contents
