Table of Contents
Advertisement
English
Fault
LEDs on the
battery
The KombiEn‐
3 LEDs light up
gine cuts out dur‐
red.
ing operation.
The KombiEn‐
gine runtime is
too short
The power levels
cannot be set.
STIHL connected
app is unable to
find the battery
with
.
19.2
Product Support and Assis‐
tance on Use
Product support and assistance on use are avail‐
able from STIHL servicing dealers.
For contacts and other information, please visit
https://support.stihl.com or www.stihl.com.
20 Specifications
20.1
KombiEngine STIHL
KMA 135 R
– Permitted batteries:
– STIHL AP
– STIHL AR
– Weight without KombiTool: 3.4 kg
The running time is shown at www.stihl.com/
battery-life.
20.2
STIHL AP battery
– Battery technology: lithium-ion
– Voltage: 36 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
– Weight in kg: see rating label
– Permissible temperature range for operation
and storage: + 10 °C to + 50 °C
– Bluetooth
®
radio interface (only for batteries
with
):
14
Cause
The KombiEngine is
too hot.
There is an electrical
fault.
The battery is not fully
charged.
The battery service
life has been excee‐
ded.
The trigger is
depressed and the
KombiEngine
switched on.
®
Bluetooth
radio inter‐
face on the battery or
mobile device is deac‐
tivated.
Distance between bat‐
tery and mobile
device is too long.
– Data connection: Bluetooth
– Frequency band: ISM band 2.4 GHz
– Maximum RF power transmitted: 1 mW
– Signal range: approx. 10 m. The signal
– Mobile appliance operating system require‐
20.3
STIHL recommends wearing ear defenders.
The exact noise and vibration specifications
depend on the KombiTool being used and are
described in the User Manual of the KombiTool.
– Sound pressure level L
ISO 11201, ISO 22868: 74.2 dB(A) to
90.5 dB(A). The K value for the sound pres‐
sure level is 2 dB(A).
Remedy
► Remove the battery.
► Allow the KombiEngine to cool down.
► Remove battery and reinsert it.
► Switch on the KombiEngine.
► Fully charge battery as described in the
User Manual for the STIHL AL 101, 301,
301-4, 500 chargers.
► Replace battery.
► Release the trigger and hold only the
trigger lockout pressed.
► Select the power level as described in
this User Manual.
► Activate Bluetooth
the battery or mobile device.
► Reduce distance,
► If the battery still cannot be found with
the STIHL connected app: Contact a
STIHL authorized dealer for assistance.
mobile appliance must be compatible with
®
Bluetooth
Low Energy 5.0 and support
Generic Access Profile (GAP).
strength depends on the ambient conditions
and the mobile terminal. Signal range can
vary greatly depending on local conditions,
including the receiver. The range may be
perceptibly reduced inside enclosed rooms
and through metal barriers (such as walls,
shelves or cases).
ments: Android or iOS (current version or
higher)
Sound Values and Vibration
Values
pA
20 Specifications
®
radio interface on
20.2.
®
5.1. The
ISO 10517,
0458-687-0121-B
Advertisement
Table of Contents
