Table of Contents
Advertisement
The filter's function is to remove suspended matter from the water, but it does not sanitize the water. For
sparkling clear water, the water must be sanitized as well as balanced. Pool chemistry is a specialized area,
and you should consult your local pool service specialist for specific details. In general, proper pool sanita-
tion requires a free chlorine level of 1 to 2 PPM and a PH range of 7.2 to 7.6.
Failure to operate your filter system or inadequate filtration can cause poor water clarity, obstructing
visibility in your pool. Poor water clarity may obscure objects in the water which, while swimming and
diving, could cause severe personal injury and death. Never swim in a pool with poor water clarity.
SECTION III. INSTALLATION
To install this filter system, you will need the follow-
ing tools - a screwdriver, wrench, and pliers.
(Refer to photo on front page for completed
assembly)
1.
Carefully remove the equipment from the
carton and check for any evidence of damage
due to rough handling or shipping. If any of
the equipment is damaged, immediately noti-
fy the organization where the equipment was
purchased.
2.
This filter should be mounted on a level con-
crete slab, or on a platform constructed of
concrete block or brick.
3.
Position the mounting base on the slab so
when the pump is mounted, the front (suction
port) of the pump is directly in-line with the
skimmer suction port from the pool.
4. Once the pump location is determined, fasten
the pump to the base using two bolts and
retaining nuts.
5. Add three complete wraps of
the threads of the hose adapters, see Figure 1,
and the threaded ends of the pump connector,
see Figure 2 and 2A. The tape is included in
the kit.
P/N 99226200
WARNING
tape to
4
REV.C 4-3-12
Advertisement
Table of Contents
