Fastening The Plinth Strip; Aligning The Base Cover - Siemens CI24R Series Installation Instruction

1.

Fastening the plinth strip

Note:
Never cover the ventilation cracks in the base pane
Risk of damage to the appliance.
Nominal dimensions to be observed:
1. Where necessary, cut the ba
length.
2. Place base cover on the appliance (do not screw
on).
3. Take the protective film off from the adhesive pa
on the Velcro strip.
4. Put the base strip onto th e base panelling and push
firmly.
5. Base strip can be screwed to the base cover from
behind. There are holes in the base cover for this
purpose.
NU
All manuals and user guides at all-guides.com
lling.
se strip to the required
ds
2.

Aligning the base cover

1. Place base cover on the appliance (do not screw
on).
2. Measure the difference in depth
base panelling and the base strip of the adjacent
lower cabinets.
3. Remove the base panelling again.
4. Adjust the brackets (a) to the dimensions
tighten.
5. Fasten the base panelling.
A between the
A and