Troubleshooting - Procedures - Sundance Spas ALTAMAR 880 User Manual

880 SERIES
17.0

Troubleshooting - Procedures

In the unlikely event your hot tub is not working the way you believe it
should, please first review all the installation and operating instructions in
this manual and check the message on the panel display; second, if you
are still not satisfied it is working properly, please follow the appropriate
troubleshooting instructions.
PrOBLeM
None of the
components
operate ( i.e.
pump, blower,
light)
Pump does not
operate and icon
does
Pump Priming instructions:
This method must be used for the jets pumps because these pumps
are not connected to the main filter system in any way.
1. Turn off the power to the spa.
2. Remove the handle from the massage selector supplied by the pump
you are priming.
Page 64
CLOSED or SHORTED FLOW SWITCH ON
SYSTEM STARTUP (system disabled) Flow switch
is non-functional. This must be repaired only by an
Sundance Spas dealer or qualified service
technician.
UV bulb needs to be replaced. The message will
flash between "blb" and the water temperature. Due
to a difference in software the "blb" message does not
occur for the Maxxus model.
PrOCedUre
Check the control panel lights.
1. If there are letters or symbols displayed on
the screen, refer to the previous section to
determine meaning and action required.
2. If nothing appears on the screen:
A. Check the household circuit breaker.
B. Contact you Sundance Spas dealer or
qualified service technician.
Depress JETS Button.
1. If no sound is detected or if a buzzing sound
is detected, turn off power to the spa and
contact your authorized dealer or qualified
service technician.
2. If motor operates, but now water flows to
jets:
A. Pump may not be properly primed. See
instructions below.
B. Contact your Sundance Spas dealer or
qualified service technician.