Table of Contents
Advertisement
22
2. Insert the single cartridge carefully into the drive slot, as
3. Gently push against the back of the cartridge until the
Figure 11. Loading a single cartridge
Unloading a single cartridge
1. To unload a single cartridge press and hold the
2. Ease the cartridge out of the drive slot and into the
shown in Figure 11. The cartridge door should face into
the drive opening.
drive pulls the cartridge into the cartridge opening. The
"Cassette" LED will light up, and the word "OPERATOR"
will be displayed on the 8-digit LED display.
Note. If you have inserted a previously unused cartridge,
the drive will automatically initialize the cartridge before
writing to it. This process takes approximately 45
seconds. Do NOT attempt to eject the cartridge or the
magazine during this process.
Open/Close button on the front panel for more than one
second.
After you press the Open/Close button, the autoloader
drive will update the system log, rewind the tape, and
then eject the cartridge. This process may take several
seconds.
loading port opening and then lift it out.
DAT Autoloader Installation Manual
/ C l
e n
O p
i v e
D r
t t e
s s e
C a
S t e
t
t e c
P r o
i t e
W r
D C
e
o s
p
Advertisement
Table of Contents
