Table of Contents
Advertisement
4
Removing shipping restraints
The Scorpion 96 is shipped with several shipping restraints to
protect the drive during shipping. These restraints must be
removed before operating the drive. The restraints must be
reinstalled before shipping.
Removing the front drawer restraints
The Scorpion 96 internal and external drives are shipped with
three metal brackets attached to the front of the drive. To
remove these brackets, follow the instructions below and see
Figure 1.
1. Loosen the two large screws on either side of the
2. Lift the horizontal metal bracket slightly and pull it outward,
3. Pull outward on each of two vertical metal brackets on
4. Store these brackets with the drive shipping materials.
To reinstall the front drawer restraints, simply reverse these
steps.
Figure 1. Removing front drawer restraints
horizontal metal bracket attached to the drive faceplate.
away from the drive faceplate, until it comes free.
either side of the face plate, until they come free.
DAT Autoloader Installation Manual
C a
s s
e t t
e
D r
i v e
O p
e n
/ C
l o s
e
D C
W r
i t e
P r
o t e
c t
S t e
p
Advertisement
Table of Contents
