18
•
Connecting the power cord
Make sure the power switch is turned of "OFF." Insert the
rectangular plug on the power cable into the power connector
on the back of the autoloader. Then plug the other end of the
cord into a grounded electrical outlet.
and attach a SCSI termination plug to the other
connector. You can purchase a terminating plug from
Seagate (part number 38-9-74000000).
If the autoloader is not the last SCSI device attached to a
host adapter, attach the cables from the computer or
other devices to either of the SCSI connectors on the
back of the autoloader. In this case, you do not need to
attach a SCSI termination plug to the drive.
DAT Autoloader Installation Manual