Table of Contents
Advertisement
DAT Autoloader Installation Manual
Changing the default settings
To change one or more of the default settings (including SCSI ID
or SCSI termination), you will need to use one of the following:
External dip-switches located on a cutout on the top of
the drive:
•
•
•
•
•
Jumpers on the back of the drive:
•
•
•
Internal dip switches located on the autoloader drawer:
•
•
•
•
SCSI ID
MRS checking
Parity checking
Data compression
Power-on self-test enable
SCSI termination
Terminator power
Remote SCSI address selection
Autoload first tape
Display orientation
Display language
Display intensity
Note. Whenever possible, power down the drive before
changing jumpers or dip switches. Your changes will take
effect when the drive is subsequently powered on.
7
Advertisement
Table of Contents
