Table of Contents
Advertisement
DAT Autoloader Installation Manual
Figure 8. Locations of power and SCSI connectors on
the back of the external autoloader.
SCSI ID
selector
connectors
To change the SCSI ID, follow the instructions below:
1. Turn off the drive.
2. Press the buttons labeled "+" or "–" until the desired
3. Turn the drive back on.
Attaching SCSI cables and setting SCSI termination
On the back of the external DAT autoloader are two SCSI
connectors, which can be used interchangeably for SCSI
connectors or terminators. Choose one of the following
options, depending on the location of the autoloader on the
SCSI chain:
•
•
SCSI
address appears in the window.
Note. Turn off your computer and all SCSI devices
before attaching SCSI cables or changing SCSI
termination.
If the autoloader is the only external SCSI device, attach
the SCSI cable from the computer to one of the two
connectors and attach a SCSI termination plug to the
other connector. You can purchase a terminating plug
from Seagate (part number 38-9-74000000).
If the autoloader is the last device in a chain of SCSI
devices, attach a SCSI cable from the next-to-last SCSI
device to one of the two connectors on the autoloader
–
0
+
17
ON/OFF
switch
Fuse
Power
connector
Advertisement
Table of Contents
