Table of Contents
Advertisement
Magnet
E
Rubber Pad
Spoke
Fig.7
Fig.8
Front Fork
S e n s o r
Band B
Sensor
Fig.10
Wire
Wire Securing
Tape
Fig.13
8
Sensor Band B
Sensor Band A
Fig.9
Marking Line
of Sensor
C e n t e r o f
the Magnet
Fig.11
Rubber Pad
Fig.14
2. Mounting to Bicycle
• Attach the magnet on the right spokes of the front wheel.
The spokes must run correctly through the inside of the
magnet as in Fig. 7.
• Attach the sensor with sensor bands A/B to the right fork.
Choose a band that fits the fork diameter (S size for up to
Parallel
24ø, L for oversize).
1. Insert the band B into the slit of band A, and put the rub-
ber pad inside of the band A (Fig. 8). Adjust the length in
order that the screw-fastening part of the bands are par-
Magnet
allel when mounted to the fork (Fig. 9).
Sensor
*To pull out the band B from band A, tug strongly.
2. Mount the adjusted bands to the fork along with the sen-
sor, by temporarily tightening the screw (Fig. 10).
3. Align the magnet's center and the sensor's marking line
(Fig. 11), and make sure of 2mm clearance between the
magnet and sensor (Fig. 12). Then tighten the screw se-
About
2 mm
curely. Cut off the excess of sensor band B.
Fig.12
• Secure the wire with tape as in Fig. 13. Wind the wire round
the outer cable upto the handlebar. When adjusting the
Bracket
length, be careful that the wire will not hinder handlebar
operation.
• By using the rubber pad, attach the bracket close to the
handlebar stem (Fig. 14).
Advertisement
Table of Contents
