inbody BPBIO320S User Manual page 42

The [Model name] is intended for use in an electromagnetic environment in which radiated RF
disturbances are controlled. Portable RF communications equipment should be used no closer than 30 cm
(12 inches) to any part of the [Model name]. Otherwise, degradation of the performance of this equipment
could result.
Immunity test Band a)
Proximity fields 380 - 390 MHz
from
RF wireless
430 – 470 MHz
Communica-
tions
IEC61000-4-3
704 – 787 MHz
800 – 960 MHz
1700 – 1990
MHz
2400 – 2570
MHz
5100 – 5800
MHz
NOTE : If necessary to achieve the IMMUNITY TEST LEVEL, the distance between the transmitting
antenna and the ME EQUIPMENT or ME SYSTEM may be reduced to 1m. The 1m test distance is
permitted by IEC 61000-4-3.
a) For some services, only the uplink frequencies are included.
b) The carrier shall be modulated using a 50% duty cycle square wave signal.
c) As an alternative to FM modulation, 50% pulse modulation at 18 Hz may be used because while it
does not represent actual modulation, it would be worst case.
42
Electromagnetic immunity
Service a) Modulation b)
TETRA 400 Pulse modula-
tion b) 18Hz
GMRS 460 FM c)
FRS 460 ±5 kHz
deviation
1 kHz sine
LTE Band13, 17 Pulse modula-
tion b) 217 Hz
GSM800:900 Pulse modula-
TETRA 800 tion b)
iDEN 820 18 Hz
CDMA 850
LTE Band 5
GSM 1800 Pulse modula-
CDMA 1900 tion b) 217 Hz
GSM 1900
DECT
LTE Band 1,2,4,25
UMTS
Bluetooth Pulse modula-
WLAN tion b) 217 Hz
802.11b/g/n
RFID 2450
LTE Band 7
WLAN 802.11a/n Pulse modula-
tion b) 217 Hz
IEC60601 Compli-
test level ance level
27 V/m 27 V/m
28 V/m 28 V/m
9 V/m 9 V/m
28 V/m 28 V/m
28 V/m 28 V/m
28 V/m 28 V/m
9 V/m 9 V/m