Advertisement
4.1 To power the antenna with digital terrestrial receiver
1. Turn on your TV set and turn on your Digital Terrestrial Receiver.
2. Press the "MENU" button on the remote control of your Digital Terrestrial Receiver. Check in the
Set-Up or Installation menu of your receiver to see if the antenna power is set to "ON". (Normally
this is indicated in the menu as ANT power, Ext Antenna power or Active antenna power.) Refer to
the user manual of your Digital Terrestrial Receiver.
3. Once you are sure that your receiver supports 5 V antenna power, switch off your receiver and
disconnect it from the 230 V main power.
4. Take the supplied "long" coaxial cable and connect the end with the "F connector" (screw type
connector) to the antenna. Carefully press the inner lead of the cable into the Female-F connector
at the back of the antenna. Turn the covering nut clockwise with your HANDS until it is fixed.
5. Connect the IEC Male end to your receiver. Normally the input connector on your receiver is
marked as "ANT" (in) or as "RF" (in). Refer to the user manual of your Digital Terrestrial Receiver.
6. Connect your receiver to the 230 V main power and switch ON your receiver and TV set.
7. Proceed to 5.0 "Antenna installation".
1. Connector: F
2. RF Out
3. Connector: IEC
4. Set-Top Box with 5V output
Fig. 3
5
Advertisement
