PART 1 • English ConTEnT 1.0 WhAT is sLiMsAT? 2.0 sAfETy insTRuCTions 3.0 hoW To insTALL? 3.1 Step 1: Where to Install? 3.2 Step 2: Installation 3.3 Step 3: Connecting the Antenna and the Set top box 3.4 Step 4: Fine Tuning and Fixing the Bracket 4.0 TRoubLEshooTing ChECk LisT foR iniTiAL insTALLATion 5.0 Loss of signAL / RAin fAdE 6.0 insTALLATion using Long CAbLE...
High Definition channels with a superior image quality. For the use and installation, please read the following instructions and installation materials carefully. slimsat sA61 with integrated single Lnb slimsat sA62 with integrated Twin Lnb...
PART 1 • English Warning!!! Antennas improperly installed to an inadequate structure are very susceptible to wind damage. This Damage can be very serious or even life threatening. The owner and installer assumes full responsibility that the installation is structurally sound to support all loads (weight, wind &...
PART 1 • English 3.2 Step 2: Installation In order to install your new antenna, you need to find the skew, elevation and azimuth angle by referring to the table in the appendix of this manual. If you can’t find your location, please refer to the information of the place nearest to your location.
PART 1 • English 3. installation of fixing bracket A When installing Fixing Bracket A (B3), please consider the place of installation (clamp type, wall mounting type). Make sure that the direction of the bracket is towards satellite. In order to support the weight of the antenna, nut (N1) should be fixed as tightly as possible.
PART 1 • English The use of a long or bad quality cable and not isolated jacks can cause a loss of the signal level, it would be preferable to use an RG6 Coaxial cable (HF 17VATC or 19VATC cable), in order to minimise a signal loss.
PART 1 • English 4.0 TRoubLEshooTing ChECk LisT foR iniTiAL insTALLATion If the signal is not found, be sure the receiver user manual and the antenna user manual have been followed closely, check the following: Make sure all cable connections are correct and each connection is seated / tightened properly. ...
PART 1 • English 5.0 Loss of signAL / RAin fAdE The satellite signal may be lost temporarily due to unusual heavy rainfall. An optimal alighted antenna, along with the shortest possible cable run, minimizes the chances of “rain fade”. Make sure the antenna is mounted securely to prevent it from being blown out of alignment in a heavy wind.
PART 1 • English A.1 box ConTEnT no symbol Part name image Quantity Antenna Body Skew Bracket Main Support Fix Bracket A Fix Bracket B Spanner...
Page 11
PART 1 • English no symbol Part name image Quantity Compass Screw M6x18 SEMS2 Screw M6x50 SEMS2 Round Head Square Neck Bolt M6x50 Round Head Square Neck Bolt M6x75 Flanged Nut M6 21 Dec 2009 14:34...