Advertisement
Quick Links
Advertisement
Related Manuals for Strong SRT ANT200
Summary of Contents for Strong SRT ANT200
- Page 1 Active Outdoor DVB-T/T2 Antenna SRT ANT200 User Manual...
-
Page 2: Table Of Contents
Subject to alterations. In consequence of continuous research and development technical specifications, design and appearance of products may change. LTE is a trademark of ETSI, all other product names are trademarks or registered trademarks of their respective owners. © STRONG 2021. All rights reserved. -
Page 3: Introduction
1.0 INTRODUCTION Thank you for purchasing the STRONG SRT ANT200 DVB-T/T2 antenna. This antenna has been specially designed to receive digital terrestrial signals. It can be connected to any Digital Terrestrial Receiver (DVB-T/ T2) and is specially designed for outdoor use. The antenna housing is weather-proof sealed. - Page 4 Outdoor TV Antenna with integrated amplifier Mount system Inserter Short coax cable 5G/4G Filter SRTANT20 IEC type male to F type female fast connector 20 m Black RG6 coaxial cable with 5 V Adapter (USB) IEC male and F-connector...
-
Page 5: Safety Notes
3.0 SAFETY NOTES *Be careful working outside with overhead power lines to avoid electrocution. Use only originally supplied accessories. „ Before you make any connections: disconnect your equipment from the 230 V main power to „ avoid electric shocks during installation. Short circuit in the coaxial cable MAY permanently damage your Digital Receiver. -
Page 6: To Power The Antenna With Digital Terrestrial Receiver
4.1 To power the antenna with digital terrestrial receiver 1. Turn on your TV set and turn on your Digital Terrestrial Receiver. 2. Press the “MENU” button on the remote control of your Digital Terrestrial Receiver. Check in the Set-Up or Installation menu of your receiver to see if the antenna power is set to “ON”. (Normally this is indicated in the menu as ANT power, Ext Antenna power or Active antenna power.) Refer to the user manual of your Digital Terrestrial Receiver. - Page 7 Option 1 Connector: F Set-Top Box with 5 V output Connector: IEC RF Out Connector: F Connector: IEC Connector: IEC...
-
Page 8: To Power The Antenna With External Power Adapter
If your receiver does not support 5 V antenna power, then please follow the next steps: 4.2 To power the antenna with external power adapter 1. Switch OFF your receiver and disconnect it from the 230 V mains power. 2. Take the short coaxial (IEC Male to IEC Female) cable. Connect the IEC Male end to your receiver. Normally the input connector on your receiver is marked as “ANT”... - Page 9 Fig.4 Option 2 Connector: F Set-Top Box without 5 V output Connector: IEC RF Out Connector: F Connector: IEC Connector: IEC...
-
Page 10: Installation Of The Antenna
NOTE: It is recommended NOT to place the antenna near to: Devices that are strong source of radiation or interference such as DECT and „ GSM telephones, transmitters, microwaves, wifi, etc.