Table of Contents
Advertisement
It is possible to turn off the ePerf Connect device using the ePerf Mobile application. To do so, please go
to the device settings (see paragraph above) and press the corresponding button.The device has to be
connected to the application. Once the command is sent, the device displays a shutdown message and will
shut down after a few seconds. Please finally select ''Update the device'' and follow the steps.
eCELSIUS PERFORMANCE CONNECT SYSTEM
The ePerf Connect device shows 5 alert categories.
The triggering and displaying conditions are summarized in the table below.
Function managed
Capsule battery
ePerf Connect
battery
Communication
loss between
capsule and ePerf
Connect
Full memory
Internal error alert
ePERF CONNECT DEVICE UPDATE
ALERTS SYSTEM VISUALIZATION
Alert condition
Remaining capsule
autonomy should
30 secondes maxi-
allow around 500
mum in case of real
measurements
time communication
maximum
ePerf Connect
battery is low or
critical
ePerf Connect
device does not
receive anymore the
real tom data from
the capsule since
5min.
The ePerf Connect
device does not
enough memory to
ensure data storage
The ePerf connect
the usability of the
device is faulty
device is limited
Tableau 1: Alert system
P063GUI001 - User guide eCelsius Performance Connect.1 - EN
Delay related
Alert mode
to the Alert
for ePerf Connect
Flashing LED
Flashing LED and
Immediate
symbol on the ePerf
Connect screen
Flashing LED and
symbol
30 periods
the screen of ePerf
Connect device
Immediate
Flashing LED
Immédiate,
Flashing LED +
message displayed on
the screen
25
Alert mode
for ePerf Mobile
Notification & display
in the ePerf connect
Parameters
Notification in case of
low battery, % of battery
displayed on the general
screen of each ePerf
Connect connected
Notification and number
of mission data dis-
played.
on
Symbol on the capsule
status
Notification & info dis-
played in
the ePerf Connect
device parameters
Advertisement
Table of Contents
Need help?
Do you have a question about the e Celsius Performance Connect and is the answer not in the manual?