Configuring Uplink Detection - Tenda AX3000 User Manual

7.6.2

Configuring uplink detection

Step 1 Choose Tools > Uplink Detection.
Step 2 Enable Uplink Detection.
Step 3
Select an operation you want the AP to perform.
Step 4 Enter the IP address of the host to be pinged in Host1 to Ping or Host2 to Ping, such as the
IP address of the switch or router directly connected to the Ethernet port of the AP.
Step 5 Enter the interval at which the AP detects its uplink in Ping Interval box. The default value
is 10 minutes.
Step 6 Click Save.
---- End
Parameter description
Parameter
Uplink Detection
Operation
Host1 to Ping
Host2 to Ping
Ping Interval
Description
It specifies whether to enable the Uplink Detection function of the AP.
Set the operation of uplink detection. This parameter can be set if Uplink Detection is
enabled.
Disable RF: The AP performs the action of disabling RF.

Reboot: The AP performs the device reboot action.

Enter the IP address of the host to be pinged. This parameter can be set if Uplink
Detection is enabled.
Set the interval at which this device detects the uplink. This parameter can be set if
Uplink Detection is enabled.
76