Subscribe to Our Youtube Channel
Related Manuals for SoundMax SM-CMD3001
Summary of Contents for SoundMax SM-CMD3001
- Page 1 SM-CMD3001 MULTIMEDIA DVD/CD/MP3 RECEIVER WITH BUILT-IN 3” TFT DVD/CD/MP3- 3” TFT- Instruction manual...
-
Page 2: Table Of Contents
Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents...2 Important safeguards ...3 Installation/Connections...4 Panel controls ...8... -
Page 3: Important Safeguards
Important safeguards Read carefully through this manual to familiarize yourself with this high-quality sound system. Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating may cause serious damage to the unit. -
Page 4: Installation/Connections
Installation/Connections First complete the electrical connections, and then check them for correctness. Installation It is an anti-theft installation way. The chassis wear a metal sliding housing. Please have the wiring connection of the power supply, speakers and antenna as for the requirement of the manual, and then install the metal sliding housing into the car according to the diagram. - Page 5 Attaching the control panel Insert the left side of the control panel into the shaft of the main unit. Push the panel to the left and insert the right side of it. Press the right side of the panel until a “click” sound is heard. Detaching the front panel Press the OPEN button on the front panel.
- Page 6 Connection diagram...
- Page 7 Notes: In spite of having any kinds of speaker system, use 4 ohms impedance of speaker to reduce the distortion during high volume level. It is prohibited to make the conductors of auto antenna and ground touch with each other. For your driving safety, please link your brake detecting wire with low power level, and keep it controlled by manual brake switch.
-
Page 8: Panel Controls
Panel controls Front panel MENU button BAND button SOURCE button Cursor buttons Microphone PTY button USB slot APS/PLAY/PAUSE button AF button 10. TA button 11. LCD display 12. VOL/ENTER knob 13. OPEN button... - Page 9 Inner panel The front panel of this unit can be detached to show the inner panel with disk slot. Press EJECT button to open the inner panel. To unload the disk press EJECT again To set the unit to the initial settings press RESET button. 14.
- Page 10 Remote control PWR button SUB-T button DI+/- buttons (OPTION) +/-/PREV/NEXT/SEL buttons CLK button N/P/ANGLE button PLAY/PAUSE button R/L/LANGUAGE button RIGHT/LEFT/UP/DOWN cursor buttons/ENTER button 10. OSD button 11. SETUP button 12. Number buttons 13. AF button 14. TA button 15. PTY button 16.
-
Page 11: General Operations
General operations Reset the unit Operating the unit for the first time or after replacing the car battery, you must reset the unit. Press OPEN button, then press the RESET button with some sharp object to restore the unit to the original factory settings. -
Page 12: Radio Operations
Radio operations Note: RDS (Radio Data System) service availability varies with areas. Please understand if RDS service is not available in you area, the following service is not available, either. BAND selection Press BAND button on the panel or on the RC repeatedly to select your desired radio band during RADIO mode: FM1, FM2, FM3, AM1, AM2. - Page 13 Hold UP/DOWN cursor buttons to store a station. To recall a station: Select a band (if needed). Press UP/DOWN cursor buttons to recall the stored station. Mono/Stereo selection Press the ST/RPT button on the RC to select ST OFF (Mono) or ST ON (Stereo) mode. TA (Traffic Announcement) function Press the TA button on the RC or on the panel to turn on or turn off the TA function.
-
Page 14: Dvd/Cd Operations
DVD/CD operations Disc glossary PBC (PlayBack Control) PBC is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it can playback interactive software with the menu displayed on TV. And if the disc contains still images, it can playback high definition of still image. - Page 15 Inserting the USB device Insert the USB device into USB jack. Press SOURCE button on the RC to go into USB mode. The first USB device track playback will start. Note: USB functions (flash memory type) MP3 music play FAT 12/FAT 16/FAT 32 is possible FAT 12/16 (dir: 200 support, file: 500 support), FAT 32 (dir: 200 support, file: 500 support).
- Page 16 Stop playback During MP3/MPEG-4/USB mode, press STOP button on the RC to stop the playback. Press it again to resume the playback. During VCD/CD mode, press STOP button to pause playing, press PLAY/PAUSE to play, and press STOP button twice to stop playing completely. To start playing, press PLAY/PAUSE button. Using the number buttons Press the numbered buttons on the RC to insert the track/chapter number.
- Page 17 Selecting subtitle language (for DVD only) If DVD disc supports multi-subtitle playback, press SUB-T button on the RC repeatedly to switch among languages. OSD (OnScreen Display) function Press OSD button on the RC repeatedly to show the current track/chapter, current time on the display. Title playing (for DVD only) During DVD mode, press TITLE/PBC button on the RC to activate the disc title list on the screen.
- Page 18 Audio/Video/Picture file operations Insert the CD with mixed files (.mp3, .jpeg, .wma, mpeg4 files), press STOP button. Category/ Folder/ File list will be displayed on the screen, and file/folder name being played will be displayed on top. Current selected item will be highlighted. Category Select 1.
-
Page 19: Operating With System Menu
Operating with System Menu To enter the System Setting Menu press MENU button. You will enter Menu pages for Video Mode, Audio Mode and System Mode using UP/DOWN/LEFT/RIGHT cursor buttons. Video Mode You may adjust the settings: BRIGHT, COLOR, CONTRAST, TINT, V.MODE (STAN => SOFT =>... -
Page 20: Mp3 & Wma Overview
MP3 & WMA overview Notes on MP3 and WMA: MP3 is short for MPEG Audio Layer 3 and refers to an audio compression technology standard. This product allows playback of MP3 files on CD-ROM, CD-R or CD-RW discs. The unit can read MP3 files written in the format compliant with ISO 9660. However it does not support the MP3 data written by the method of packet write. - Page 21 You should not write non-MP3 files or unneeded folders along with MP3 files on the disc otherwise it takes a long time until the unit starts to play MP3 files. With some CD-R or CD-RW media, data may not be properly written depending on their manufacturing quality.
-
Page 22: System Setup Menu
System setup menu Press the SETUP button on the RC to display the system setup menu. Use LEFT/RIGHT cursor buttons on RC to select the desired menu: System setup, Language setup, Video setup. Press ENTER to enter it. Use the UP/DOWN cursor buttons to select the needed setting. Press RIGHT to enter the setting adjustment sub window. - Page 23 Language setup OSD language Select the OSD language. Audio language Select the audio language (if DVD disc supports several audio languages). Subtitle language Select the subtitle language (if DVD disc supports several subtitle languages). Menu language Select the DISC menu language (if DVD disc supports several menu languages).
-
Page 24: Accessories
Accessories Receiver Remote control ISO connector Frame Mantle Keys Customer information Warranty card Instruction manual Back view camera This unit is equipped with back view camera output. The camera is used to observe the situation behind the vehicle when you are backing the car. Please connect your back view camera with the back car video input. -
Page 25: Anti-Theft System
Anti-theft system This unit is equipped with a slide-down detachable and mask panel. Panel can be detached and taken with you, helping to deter theft. Handling compact discs Dirty, scratched or warped discs may cause skip ping or noise. Handle the disc only by the edges. To keep clean do not touch its surface. Discs should be stored in their cases after use to avoid scratches. -
Page 26: Troubleshooting Guide
Troubleshooting guide Symptom No power The car ignition is not on. The fuse is blown. Disc cannot be loaded. Presence of CD disc inside the player. Disc cannot be read. Inserting the disc in upside down. Compact disc is extremely dirty or defective. -
Page 27: Specification
Specification General Power supply Maximum power output Fuse Dimensions (L x W x H) Supported storages Supported formats FM stereo radio Frequency range Storable stations Display Display Aspect ratio Video system Resolution Brightness Contrast View angle AM Section Frequency range Storable stations Line out Specifications are subject to change without notice. - Page 28 ... 28 ... 29 ... 30 ... 34 ... 37 ... 38 DVD/CD ... 40 ... 45 WMA ... 46 ... 48 ... 50 ... 50 ... 50 ... 51 ... 51 ... 53 ... 52...
- Page 34 MENU BAND SOURCE APS/PLAY/PAUSE VOL/ENTER OPEN...
- Page 35 14. SD- RESET EJECT RESET. OPEN,...
- Page 36 SUB-T DI +/- ( +/-/PREV/NEXT/SEL N/P/ANGLE PLAY/PAUSE R/L/LANGUAGE ENTER/ SETUP GOTO TITLE/PBC STOP ST/RPT APS/PRG BAND/RDM MUTE SOURCE (CR2025).
- Page 37 OPEN, RESET SOURCE SOURCE SOURCE, : RADIO => DISC => SD => USB => BACK VIEW => INPUT. MUTE, : NORM => ROCK => POP => CLAS. MENU (System mode),...
- Page 38 RDS ( BAND FM1, FM2, FM3, AM1, AM2. PREV/NEXT NEXT/PREV NEXT/PREV APS/PLAY/PAUSE PWR. APS/PLAY/PAUSE APS/PLAY/PAUSE...
- Page 39 ST/RPT TA ( AF ( PTY ( PTY, RDS ( (18 FM, 12 AM), NEXT/PREV ST OFF ( ST ON (...
- Page 40 DVD/CD PBC ( – : DVD/SVCD/VCD/HDCD/MP3/MP4/WMA/CDDA/Picture-CD/JPEG. : MP3 (*.mp3) WMA (*.wma) : MPEG 2(*.vob) MPEG 1(*.dat) : JPEG (*.jpg) ISO 9660 ISO 9660 + – PBC, Joliet - : 32 - 320 : *.ACC, *.DLF, *.M3U, *.PLS, MP3 PRO, : CD/DVD/DVD±R/CD-R/-RW. 44,1 DRM.
- Page 41 FAT 12/ FAT 16/ FAT 32 FAT 12/ 16 ( FAT 32 ( , 500 : 32 (id3tag USB: USB 2.0. SD/MMC Sharp, Samsung, MMC: OPEN EJECT PLAY/PAUSE PLAY/PAUSE USB. SRC/PWR SOURCE, , 500 : 32 : Cannon, Fuji film, Palm, Motorola, Microsoft, IBM, HP, Compaq, : Ericsson, Nokia, Motorola, HP, Palm, Sanyo, Microsystems, STOP APS/PLAY/PAUSE...
- Page 42 MP3/MPEG4/USB: PLAY/PAUSE, VCD/CD PLAY/PAUSE, PREV ST/RPT => REP OFF ( => REP OFF ( VCD/CD R/L/LANGUAGE ), STEREO ( STOP NEXT : REP CHAPTER ( ) => REP TITLE ( : REP ONE ( ) => REP DIR ( : REP ONE ( ) =>...
- Page 43 N/P/ANGLE, DVD, PBC ( ENTER, PBC, DVD/VCD/CD ) => Audio ( : NTSC => PAL => AUTO. TITLE/PBC PBC, STOP, SUB-T GOTO : Title ( ) => Chapter...
- Page 44 ENTER, AUDIO PICTURE VIDEO. ENTER, ENTER STOP, ID3, APS/PRG (.mp3, .jpeg, .wma, mpeg4), 1.0. . ID3 VCD/CD PLAY. ENTER, STOP. MP3/WMA...
- Page 45 VIDEO ( CONTRAST ( ), TINT ( USER) ( AUDIO ( ), TREBLE ( ), FADER ( ) (NORM, ROCK, JUZZ, CLAS, POP ( BEEP, TOPIC, TIME DISP ( MENU. BRIGHT ( ), COLOR ( ), V.MODE ( ) (STAN, SOFT, : BASS ( ), BALANCE ( : LOUD (...
- Page 46 WMA: “.mp3”. PC “ ” “ . VBR: WMA (Windows Media Audio) – Corporation. , 64 44,1 MPEG 3 ” 256. VBR, CD-R CD-RW, CD-ROM, CD-R CD-RW. ISO 9660. “.mp3”, “ MP3” “ Microsoft ”,...
- Page 47 ISO 9660, CD-R MP3 CD-R CD-RW CD-R CD-RW CD-R CD-RW 1. ID3TAG.
- Page 48 SETUP ENTER, NTSC: PAL: 4:3 PS: 16:9: – 0000.
- Page 49 DIVX DivX, DivX. DIVX : 4.0, 5.0, 6.0.
- Page 50 SOURCE Back View (...
- Page 52 « ». RESET.
- Page 53 12 , DVD/DVD±R/DVD±RW/CD/CD-R/CD-RW/USB/SD/MMC DVD/SVCD/VCD/MP3/MP4/WMA/CDDA/JPEG/MPEG4 87,5 – 108,0 522 – 1620 16:9 PAL/SECAM/NTSC 480 x 234 300:1 : 110 , : 120 RCA- (2V)
Need help?
Do you have a question about the SM-CMD3001 and is the answer not in the manual?
Questions and answers