Travis Industries 98500677 Quick Start Manual

Compatibility:
564 TRV (w Screen) 564 HO (w Screen)
864 TRV (w Screen) 864 HO (w Screen)
Note: This setup face is not for use with CleanFace fireplaces (564 CF, 864 CF)
Note: This set-up face may be re-used – re-attach the components for future use.
Dimensions – Packing/Un-Packing the Face
All of the components needed to attach the setup face are shipped pre-
attached to the face. Before installing, remove all of the screws/brackets
shown below. After installation, re-attach the screws/brackets in the same
fashion. NOTE: Extra holes are included for the #8 screws if the existing
holes become stripped.
564 = 36-1/4"
864 = 41"
564 = 29-1/4"
864 = 35-3/4"
Page 1 of 1
Rectangular Setup Face
98500677 (564 Version)
564 25k 564 35k
864 ST (w Screen) 864 TV 40k
Attaching the Setup Face to the Fireplace
HINT:
1
2
SIDE OF
FIREPLACE
3
1"
NOTE: To avoid a gap below the face, make sure the hearth is installed up to the bottom flange of
17602101
98500689 (864 Version)
Packing List:

Rectangular Setup Face

Upper Protector

(2) Mounting Brackets
Cut down the cardboard dust cover and place it behind the setup face to prevent
construction debris from entering the fireplace).
Attach the mounting brackets to the fireplace following the directions below.
Attach the setup face to the mounting brackets following the directions below.
Attach the mounting brackets to the
fireplace with the included #8 screws.
Use the upper screw
holes (extra holes are
required to make the
brackets left/right
compatible).
Once in place facing may be installed around the perimeter of the setup face (do not install any
facing in front of the setup face). Once the facing is installed (and cured) the setup face may be
removed and stored for future use.
the setup face.
10/16/20

(6) #8 x 3/8" Screws

(4) 10-24 Screws
Attach the setup face to
the brackets with the
included 10-24 screws.
Make sure
the arrows
point up.
Finish up to the
flanges on all 4
sides of setup face
© Travis Industries, Inc.