Page 1
How to config network parameters and Pair the Module This document is only using for Flylink HD . Flylink HD : RAK566(TX) and RA554(RX). RAK5610 is same with RAK554 including firmware and Hardware. 1 RAK554 PIN Definition 2 RAK554 Dip switch definition There are 6 group Dial-up in the module .
Page 2
3 How to change SSID and PSK RAK553 will work as OPEN network .if you have to change the SSID and PSK .please following the steps strictly. Note: Once you change the network parameters, you have to make a new connection with Transmitter.
Page 3
5 Make new Pair Transmitter(STA): RAK566. Step1 : Power on RAK566 waiting the board blink or lighting more than 10 seconds . Step2 : Power on RAK554(RX) and waiting for blue LED turn on . Toggle Receiver’s DIP switch PIN1 to Low-Level more than 1 second and then Toggle to High-Level .The blue LED will be quick flashing.