Safety Instructions; About This Chapter; Intended Use - Aventics Marex ECS Assembly Instructions Manual

8 AVENTICS | ECS Actuator | R417002911–BDL–001–AA

Safety instructions

2 Safety instructions
2.1

About this chapter

The Marex ECS Actuator has been manufactured in strict
compliance with the generally accepted rules of technology.
However, this does not exclude the risk of damage to persons or
property if the general safety instructions in this chapter and
the safety instructions in this document are not observed.
Read these assembly instructions completely and carefully
before starting to operate the Marex ECS Actuator.
Keep these assembly instructions in a location where they
are accessible to all users at any time.
Always include these assembly instructions when passing
the control head on to third parties.
2.2

Intended use

The Marex ECS Actuator is used to control ship propulsion
systems. It is designed for the application in the engine control
room (power generation/distribution area) of small boats,
yachts or small commercial vessels. It may be used with diesel
engines only.
The Marex ECS Actuator may only be used with Marex ECS
under the conditions described in these assembly instructions
(see also chapter 1.2).
A separate emergency stop switch must be provided on every
control station.
Comply with the operating conditions and performance
limits stated in chapter 13.
The actuators described in this document cannot be
combined with the following components of the first
generation MarexECS:
R417002550
R417002400