Lubrication Diagram - JLG 26MRT Service & Maintenance

SECTION 1 - SPECIFICATIONS
INDEX
COMPONENT
NO
1 Wheel Bearings
2 Hydraulic Oil
3 Hydraulic Return Filter
4 Charge Pump Filter
5 Crankcase - Vanguard Gasoline/LP
Engine
6 Crankcase - Yanmar Diesel Engine
7 Rear Axle
KEY TO LUBRICANTS:
EO - Engine Oil
EPGL - Extreme Pressure Gear Lubricant
HO - Hydraulic Oil - Mobilfluid 424
MPG - Multi-purpose Grease
TO AVOID PERSONAL INJURY, USE SAFETY PROP FOR ALL
MAINTENANCE REQUIREING PLATFORM TO BE ELEVATED.
1-4
Figure 1-1. Lubrication Diagram
Table 1-6. Lubrication Chart
NUMBER/TYPE LUBE POINTS
2- Front Wheels
Fill Cap/Drain Plug
N/A
N/A
FillCap/Drain Plug
FillCap/Drain Plug
FillCap/Drain Plug
NOTE: 1. Be sure to lubricate like items on each side.
– JLG Sizzor –
LUBE METHODS
MPG - repack
HO - Check HO Level
HO - Change HO
N/A
N/A
EO - Check EO Level
EO - Change EO
EO - Check EO Level
EO - Change EO
EPGL - Check EPGL Level
EPGL - Change EPGL
2. Recommended lubricating intervals are based
on maching operations under normal conditions.
For machines used in multi-shift operations and/or
exposed to hostile environments or conditions,
lubrication frequencies must be increased accord-
ingly.
3. Operate hydraulic functions through one com-
plete cycle before checking hydraulic oil level in
tank. Oil should be visible in ADD sight window on
hydraulic tank. If oil is not visible, add oil until oil is
visible in both ADD and FULL sight windows on
tank. Do not overfill tank.
INTERVAL
HOURS
1200
Daily/1200
50/300
50/300
Daily/50/300
Daily/50/300
150/1200
3120791