DeLonghi Eletta ECAM45.760.W Manual page 18

GROUND TOO FINE ADJUST
MILL
INSERT GROUNDS CONTAINER After cleaning, the grounds container has not
ADD PRE-GROUND COFFEE
DESCALE
d
REDUCE COFFEE AMOUNT
FILL BEANS CONTAINER
-
-
INSERT INFUSER ASSEMBLY
INSERT TANK
GENERAL ALARM
EMPTY CIRCUIT FILL CIRCUIT
alternating with
HOT WATER
Press OK
REPLACE FILTER
SET DIAL TO CLEAN
INSERT WATER SPOUT
The grinding is too fine and the coffee is delive-
red too slowly or not at all.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
been replaced (A10).
With the "pre-ground coffee" function selected,
pre-ground coffee has not been poured into the
funnel (A4).
The machine must be descaled.
Too much coffee has been used.
The coffee beans have run out.
The pre-ground coffee funnel (A4) is clogged.
The infuser has not been replaced after clea-
ning (A15).
The tank (A6) is not correctly in place.
The inside of the appliance is very dirty.
The water circuit is empty
The water softener filter (C4) is exhausted.
Milk has been delivered recently and the tubes
inside the milk container must be cleaned (D).
The hot water spout (C6) is not inserted or is
inserted incorrectly
131
Repeat coffee delivery and turn the grin-
ding adjustment dial (A5, fig. 14) one click
clockwise towards "7" while the coffee mill is
in operation. If after making at least 2 coffees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click (section "9.5 Adjusting the
coffee mill").
Insert the hot water spout (C6) in the appliance
and deliver a little water until the flow beco-
mes regular.
Remove the drip tray (A12) and insert the
grounds container.
Place pre-ground coffee in the funnel or dese-
lect the "pre-ground" function (fig. 18).
The descaling procedure described in section
"13. Descaling" needs to be performed as soon
as possible.
Select a milder taste by pressing the
button (B2- fig. 11) or reduce the quantity of
pre-ground coffee.
Fill the beans container (fig. 15).
Empty the funnel with the help of the brush
(C5) as described in section "12.8 Cleaning the
pre-ground coffee funnel".
Insert the infuser as described in section "12.9
Cleaning the infuser".
Insert the tank correctly and press as far as it
will go.
Clean the inside of the appliance thoroughly,
as described in section "12. Cleaning". If the
message is still displayed after cleaning, con-
tact a service centre.
Press OK (B12- fig. 10) to deliver water from
the spout (C6) until it flows out normally. If the
problem persists, make sure the water tank
(A16) is fully inserted.
Replace the filter or remove it as described in
section "15. Water softener filter"
Turn the froth adjustment dial (D1) to the
CLEAN position.
Insert water spout as far as it will go.