Ducati MULTISTRADA V2 2022 Owner's Manual page 92

To reach adjuster (3) it is necessary to remove the
rider seat and cover (4) next to the battery.
It is possible to work on adjuster (3) through the
opening on the battery support.
Turn adjusters (1) and (3) or knob (2) clockwise or
counter-clockwise respectively to stiffen or soften
the damping or the preload.
STANDARD setting.
Loosen:
rebound: adjuster (1) by 9 clicks from the fully
●
closed position;
preload: knob (2) by 8 clicks from the fully open
●
position;
compression: adjuster (3) by 1.5 turns from the
●
fully closed position.
Recommended calibration carrying maximum load
(bags, top case and passenger) and carrying bags
and top case.
Proceed as follows:
1) rebound: unscrew adjuster (1) by 5 clicks from
the fully closed position;
2) preload: fully screw knob (2): MAX = 12 mm (0.47
in);
3) compression: unscrew adjuster (3) by 0.5 turns
from the fully closed position.
Attention
The shock absorber is filled with gas under
pressure and may cause severe damage if taken
apart by unskilled persons.
When carrying a passenger and luggage, set the rear
shock absorber spring to proper preload to improve
motorcycle handling and keep safe clearance from
the ground.
You may find that rebound damping needs adjusting
as well.
91