Table of Contents
Advertisement
4.3
Strip Setup Options (Menu/Strip)
4.3.1
Setting Measurement Unit
The Menu/Strip/Unit menu allows the measurement units of the test results to be
selected for printed reports and the LCD.
Options are:
The units can be selected with the UP and DOWN buttons or by directly marking
the field near the desired unit type. Store the changes and return to main menu
by pressing OK.
4.3.2
Setting the Sensitivity Attribute of the Image Processing
Program
Select the Menu/Strip/Sensitivity menu to adjust the sensitivity. Measurement
sensitivity in the program can be adjusted on two levels in both directions (+/-) for
each pad. In figure 7 the display shows the default setting for sensitivity.
The sensitivity change of each
pad can be adjusted separately.
Only one selected pad sensitivity
can be changed at one time with
the help of the UP and DOWN
control buttons. When the desired
sensitivity value of the previously
selected test pad appears the
newly selected value is set by
pressing the NEXT button. After
the
last
pad
complete,
store
return to the main menu by
pressing the OK button.
Note: When the reader has been adjusted to settings different from the standard
HUMAN settings this will be indicated by asterisks in the footer of the printout.
10/22
Conventional
SI
Arbitrary
Conventional + Arbitrary
SI + Arbitrary
adjustment
is
changes
and
Figure 7. Setting pad
sensitivity
User Manual COMBILYZER Plus
Advertisement
Table of Contents
