Page 3
No part of this documentation may be reproduced in any form, nor processed, copied or distribut- ed by means of electronic systems, without prior permission of Human GmbH in writing. Since all precautionary measures were taken into account in producing these operating instructions, the manufacturer accepts no responsibility for any errors or omissions.
For cleaning use only materials specified in this manual, otherwise parts may become damaged. It is recommended always to wear protective apparel and eye protection while using this instrument. Respective warning symbols, if appea- ring in this manual, should be carefully considered. HumaRock | User manual...
Safety InStructIonS 1.5 Disposal Management Concept The currently valid local regulations governing disposal must be observed. It is in the responsibility of the user to arrange proper disposal of the individual components. All parts which may comprise potentially infectious materials have to be disinfected by suitable validated procedures (autoclaving, chemical treatment) prior to disposal.
1.8 Symbols Warning! Read the operating instructions carefully before use. Ensure that only trained staff works with the instrument. Protective ground contact! Ensure the socket must be grounded (protective ground contact) before use. HumaRock | User manual...
Chapter 1. Do not use the accessories recommended by the manufacturer, or failure to use the instructions, may be caused unsafe situation. The HumaRock rocking shaker is manufactured in accordance with the follow- ing standards: EN 61010-1, EN 61326-1 2.1 Unpacking...
Speed control knob Set target speed. Power switch Switch ON/OFF instrument. Power interface Connect the power cable Power light Green LED display light 2.3 Abbreviations revolutions per minute watt volt Hertz kilogram milimeter centimeter mililiter decibel HumaRock | User manual...
routIne utIlIzatIon 3 ROUTINE UTILIZATION 3.1 Operation Place the instrument in safe and stable surface, ensure the required opera- ting voltage and power supply voltage matched. Connect the power cable. Install the platform. Switch ON the instrument. Rotate the speed control knob clockwise to set target speed, and the shaking function will be switched on.
MaIntenance 4 MAINTENANCE Proper maintenance can keep instrument working properly and lengthen its lifetime. Do not spray cleanser into the instrument when cleaning. Do not remove the power line when cleaning. Only use recommended clean- sers: Dyes Isopropyl alcohol Construction Materials Water containing tenside / Isopropyl alcohol Cosmetics Water containing tenside / Isopropyl alcohol...
troubleShootIng 5 TROUBLESHOOTING When switched ON, the instrument does not work Check whether the power cable is connected Motor speed cannot reach set value Check whether it is overloaded...
Protection class acc. DIN EN60529 IP21 Maximum altitude 4000m Noise level <50 dB 6.2 Accessories and Consumables Cat. No. Descriptions HumaRock, Analog Rocking Shaker, See-saw wave, angle 7, 14570 US/UK/EU plug, 100V-240V, 50Hz/60Hz Accessories Cat. No. Descriptions 14570/10 Universal attachment with 3 bars 14570/20...
Page 20
Fixing clip for flask volume 50 ml 14570/17 Fixing clip for flask volume 100 ml 14570/18 Fixing clip for flask volume 200/250 ml 14570/19 Fixing clip for flask volume 500 ml Bar for 14570/10 Universal attachment, 14570/14 black HumaRock | User manual...