Setting Serial Output Port; Setting The Language - Human COMBILYZER Plus User Manual

4.2.2

Setting Serial Output Port

The serial output port can be set
in the Menu/Setup/Serial menu
(see figure 6). If enabled, the
instrument is programmed
communicate with
computer in two ways: either PC
unidirectional or network mode.
Choose between
protocols with the UP and DOWN
buttons or by directly selecting the
circle next to the desired protocol.
In network mode, information is
sent in blocks. The blocks are
arranged either
number (Seq. Nr.) or by patient ID.
(set by the user in advance by selecting or unselecting the B1. ID.) identifies the
result reports. The standard mode setting is 9600 Baud, 8 bits with 1 Stop bit and
no parity. Other options can not be programmed. For more information on the
serial port refer to section 4.8.
Note: By disabling the serial port, the printer will be disabled, too. In this case,
the test results will appear only on the display.
4.2.3

Setting the Language

Select the Menu/Setup/Language menu to set the language. The instrument is
programmed to communicate with the user in the following languages: English,
German or Hungarian. The language can be selected with the UP and DOWN
buttons or by directly marking the field next to the desired language. Store the
changes and return to main menu by pressing OK.
User Manual COMBILYZER Plus
to
a host
the two
Figure 6. The serial setup menu
by sequence
9/22