Samsung NV70F37 Series User Manual page 290

Installation in the cabinet
With built-in furniture, plastic surfaces and adhesive for the oven should be resistant to 90 °C inside of
the furniture and to 75 °C for adjacent furniture. Samsung will take no responsibility for damage of plastic
surfaces or adhesive from the heat.
1
545
560
595
595
21
min.
3
min. 560
550
min. 50
Lower element
Push the appliance completely into the cabinet and fix the oven firmly on both sides using 2 screws.
Make sure that a gap of at least 5mm should be left between the appliance and the adjacent cabinet.
After installation, remove the vinyl protective film, tape, paper and accessories from the door and inside
of oven. Before uninstalling the oven from the furniture, disconnect the oven from the power supply and
release the 2 screws on the both sides of the oven.
WARNING: The built-in furniture must have a minimum ventilation gap for Air-flow as shown
on picture. Do not cover this hole with strips of wood, for this is used to provide ventilation.
The front exterior of the oven such as handle is different model by model. But the size of the
oven in the picture is same.
NV70F3784LB_OL_DG68-00522K-01_EN.indd 10
2
Lower
element
572
Airflow through the ventilation gap
4
50
min. 590
min. 600
-max. 600
min. 560
Top element
English - 10
There should be a ventilation gap
Top
in the base of the kitchen cabinet
element
where the oven is to be placed. For
ventilation, a gap of about 50mm
should be left between the lower shelf
and the supporting wall. If the oven is
to be installed below a hob, the hob's
installation instructions should be
followed.
5
min. 550
2014-05-05 5:22:08