Subscribe to Our Youtube Channel
Related Manuals for Labnet I-4001-HCS
Summary of Contents for Labnet I-4001-HCS
- Page 1 Labnet Microtube Shaking Incubator Instruction Manual Catalog Numbers: I-4001-HCS I-4002-HCS...
-
Page 2: Table Of Contents
Table of Contents 1.0 Introduction ..................1 2.0 Symbols and Conventions . -
Page 3: Introduction
Otherwise, the safeguards provided by the Labnet Microtube Shaking Incubator are likely to be damaged, the rated safety level to be reduced, or the rated operation conditions can be affected. Labnet shall not be in any way responsible for the consequences resulting from an operator not observing the following requirements. -
Page 4: Package Contents
The Labnet Microtube Shaking Incubator should not be operated in close proximity to water sources, such as pools and water pipes. Never cover or obstruct the openings of the Labnet Microtube Shaking Incubator, which are designed for ventilation and to prevent the device’s interior from becoming too hot. When a single device is running, the shortest distance between its openings and the nearest object should be at least 20 inches (50 cm);... -
Page 5: Specifications
Block temperature uniformity ≤±0.5°C 300 to 1,500 rpm Mixing rate Amplitude 3 mm The Labnet Microtube Shaking Incubator is designed to be safe at least when operated under the following conditions: Indoor use Pollution Degree 2 Instruction Manual... -
Page 6: Equipment Overview
Case (main body) Sticker Power connector, fuse, and power switch Temperature increasing Actual temperature Constant temperature Set temperature Temperature decreasing Actual vibration time Timer Set vibration time Actual vibration speed Vibration speed Set vibration speed LABNET MICROTUBE SHAKING INCUBATOR... -
Page 7: Operation Guide
Temperature buttons Temp Press to adjust the value and set the requested temperature. Temp Hold the to help speed up the setting time. Vibration time buttons Time Press to adjust the value and set the requested vibration time. Time Hold the to help speed up the setting time. -
Page 8: Pulse Vibration
(high then low), please reorder the temperature points to the recommended order when calibrating. TEMP TEMP TEMP TIME TIME TIME TEMP TEMP TEMP SPEED SPEED SPEED TIME TIME TIME TEMP TEMP TEMP TEMP TEMP TEMP TEMP TEMP TEMP TIME TIME TIME TIME TIME TIME TIME TIME TIME LABNET MICROTUBE SHAKING INCUBATOR... -
Page 9: Buzzer Set Up
SPEED SPEED SPEED TEMP TEMP TEMP SPEED SPEED SPEED TEMP TEMP TEMP TIME TIME TIME TIME TIME TIME TIME TIME TIME TEMP TEMP TEMP TEMP TEMP TEMP SPEED SPEED SPEED TEMP TEMP TEMP TEMP TIME TEMP TEMP TEMP TIME TIME TEMP TEMP TIME... -
Page 10: Troubleshooting And Repair
Should you have a question about the operation of the Labnet Microtube Shaking Incubator or if service is required, contact Customer Service. Do not send in a unit for service without first calling to obtain a repair authorization number. Should the unit require return for service, it should be properly packed to avoid damage. -
Page 11: Spare Parts And Accessories
9.0 Spare Parts and Accessories Spare Parts Cat. No. Description Quantity BYQ121L00000020 L socket head wrench BYQ900800000070 Cushioning balls for foot BYQ15412A000020 Fuse used for 120V model (125V, 2.5A, 5 x 20 mm) BYQ15411A500170 Fuse used for 230V model (250V, 1.5A, 5 x 20 mm) Accessories Cat. -
Page 12: Limited Warranty
(WEEE), this product is marked with the crossed-out wheeled bin and must not be disposed of with domestic waste. Consequently, the buyer shall follow the instructions for reuse and recycling of waste electronic and electrical equipment (WEEE) provided with the products and available at www.corning.com/weee. LABNET MICROTUBE SHAKING INCUBATOR... - Page 13 To request certificates, please contact us at www.labnetlink.com. Warranty/Disclaimer: Unless otherwise specified, all products are for research use or general laboratory use only.* Not intended for use in diagnostic or therapeutic procedures. Not for use in humans. These products are not intended to mitigate the presence of microorganisms on surfaces or in the environment, where such organisms can be deleterious to humans or the environment.
Need help?
Do you have a question about the I-4001-HCS and is the answer not in the manual?
Questions and answers