Dab Antenna Installation; Wiring Diagram - Caliber RMD 056DAB-BT Manual

DAB
ANTENNA INSTALLATION
Place the antenna on the windshield near the 'A post'
Remove the cover of the A-post
Attach to the metal of
the car frame.
Please note!
It's not necessary to
remove any paint!
The active DAB+ antenna is powered through
the core of the antenne wire (+5V).
No need to connect a seperate power source.
Stick the transparant part of the
antenna on the windshield and put the
black part on the metal frame.
Male SMA
RMD

WIRING DIAGRAM

White: Front Left CH RCA ouput
Red: Front Right CH RCA ouput
Red: Rear Right CH RCA ouput
White: Rear Left CH RCA ouput
Connector A
1. --
2. --
3. --
4. Memory +12V (yellow wire)
5. Remote +12V output (blue wire)
6. --
7. +12V ignition (red wire)
8. Ground (black wire) .
Microphone IN
(3,5mm jack)
Connector B
1. Right rear speaker (+)
2. Right rear speaker (-)
3. Right front speaker (+)
4. Right front speaker (-)
5. Left front speaker (+)
6. Left front speaker (-)
7. Left rear speaker (+)
8. Left rear speaker (-)