Fein Slugger HoleMaker III Instruction Manual page 8

en
8
Intended use of the power tool:
Magnetic core drill unit for drilling with core
drill bits and solid drill bits on materials with
magnetizable surfaces in weather-protected
environments using the application tools
and accessories recommended by Slugger.
Operation of the power tool off power generators.
This power tool is also suitable for use
with AC generators with sufficient
power output that correspond to the Stan-
dard ISO 8528, design type G2. This Stan-
dard is particularly not complied with when
the so-called distortion factor exceeds
10 %. When in doubt, please refer to the
generator instruction/specification guide.
Observe the operating instructions and the
national regulations for the installation and
operation of the AC generator.
Symbols.
Symbol, character
In environments subject to interference, a
reduction of the operating quality is possi-
ble; this can include temporary failure, tem-
porary reduction of the function or the
intended operating behaviour, for the cor-
rection of which intervention by the opera-
tor is required.
load speed exceeds the voltage value on the
type plate of the power tool is prohibited.
Explanation
Make sure to read the enclosed documents such as the
Instruction Manual and the General Safety Instructions.
Observe the instructions in the text or graphic opposite!
Observe the instructions in the text or graphic opposite!
Before commencing this working step, pull the power plug
out of the socket. Otherwise there will be danger of injury
if the power tool should start unintentionally.
Use eye protection during operation.
Use ear protection during operation.
Do not touch the rotating parts of the power tool.
Warning against sharp edges of application tools, such as
the cutting edges of the cutter blades.
Danger of slipping!
Danger of crushes or contusions!
Operating the power tool off
WARNING
power generators whose no-