Fein Slugger HoleMaker III Instruction Manual page 25

Table of Contents

Advertisement

Available languages

Available languages

Feed (figure 15).
Work only with the absolutely required
amount of feed. Excessive feed can lead to
breakage of the application tool and loss of
the magnetic holding power.
To generate feed, turn the spoke handle
manually while the drill motor is switched
on.
Mounting the spoke handle is described
under „Mounting the spoke handle".
Instructions for core drilling.
Only remove the cutting tool from the hole
while the motor is running.
If the carbide tipped cutter should remain
stuck in the material, stop the drill motor
and carefully turn the carbide tipped cutter
out counterclockwise.
After each drilling operation, remove the
chips and the slug.
Do not touch the chips with your bare
hands. Always use a chip hook
(6 42 98 160 40 0).
For core drilling in layered material, use a
suitable Slugger ID cutter.
When changing a cutting tool, pay attention
not to damage the cutting edges.
When core drilling layered material, remove
the core and the chips after having drilled
through each layer.
Fig. 15
en
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

Slugger usa 202 m

Table of Contents