Table of Contents
Advertisement
Installing the antennas
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the antennas and provides a visual representation of the installation procedure.
NOTE:
Note the location of the antenna modules that are printed on the display-assembly base as ANT-B (black) and
ANT-W (white).
Steps
1. Align and place the antenna modules (2) into the slots on the display-assembly base and adhere it in place.
2. Adhere the copper foil that secures the antenna cables (2) to the display-assembly base.
3. Route the antenna cables through the routing guides on the display-assembly base.
Next steps
1. Install the
power-button
2. Install the
display
hinges.
3. Install the
media-card
4. Install the
system
board.
5. Install the speakers.
6. Install the
heat
sink.
7. Install the
wireless
card.
8. Install the
M.2 2230 solid-state drive
9. Install the
memory
module.
10. Install the
system-board
11. Install the
hard
drive.
12. Install the
I/O
cover.
13. Install the
back
cover.
14. Install the stand.
15. Follow the procedure in
58
Removing and installing components
board.
reader.
or
M.2 2280 solid-state
shield.
After working inside your
drive.
computer.
Advertisement
Table of Contents
