Log Into The Device Manager - Cisco Firepower 1010 Getting Started Manual

Threat Defense Deployment with the Device Manager
• If your networking information has changed, you will need to reconnect—If you are connected with
• Manage the device locally?—Enter yes to use the device manager or the CDO/device manager. A no
Example:
You must accept the EULA to continue.
Press <ENTER> to display the EULA:
End User License Agreement
[...]
Please enter 'YES' or press <ENTER> to AGREE to the EULA:
System initialization in progress.
You must configure the network to continue.
You must configure at least one of IPv4 or IPv6.
Do you want to configure IPv4? (y/n) [y]:
Do you want to configure IPv6? (y/n) [n]:
Configure IPv4 via DHCP or manually? (dhcp/manual) [manual]:
Enter an IPv4 address for the management interface [192.168.45.45]: 10.10.10.15
Enter an IPv4 netmask for the management interface [255.255.255.0]: 255.255.255.192
Enter the IPv4 default gateway for the management interface [data-interfaces]: 10.10.10.1
Enter a fully qualified hostname for this system [firepower]: ftd-1.cisco.com
Enter a comma-separated list of DNS servers or 'none' [208.67.222.222,208.67.220.220]:
Enter a comma-separated list of search domains or 'none' []:
If your networking information has changed, you will need to reconnect.
For HTTP Proxy configuration, run 'configure network http-proxy'
Manage the device locally? (yes/no) [yes]: yes
>
Step 4
Log into the device manager on the new Management IP address.

Log Into the Device Manager

Log into the device manager to configure your threat defense.
Before you begin
• Use a current version of Firefox, Chrome, Safari, Edge, or Internet Explorer.
Procedure
Step 1
Enter the following URL in your browser.
system uses the gateway provided by DHCP and uses the data-interfaces as a fallback method if DHCP
doesn't provide a gateway.
SSH to the default IP address but you change the IP address at initial setup, you will be disconnected.
Reconnect with the new IP address and password. Console connections are not affected.
answer means you intend to use the management center to manage the device.
Please stand by.
Cisco Firepower 1010 Getting Started Guide
Log Into the Device Manager
99