Cisco Firepower 1010 Getting Started Manual page 151

Threat Defense Deployment with CDO
You already pre-configured this interface for manager access, so the interface will already be named, enabled,
and addressed. You should not alter any of these basic settings because doing so will disrupt the management
center management connection. You must still configure the Security Zone on this screen for through traffic
policies.
a) From the Security Zone drop-down list, choose an existing outside security zone or add a new one by
clicking New.
For example, add a zone called outside_zone.
b) Click OK.
Step 7
Click Save.
Configure the DHCP Server
Enable the DHCP server if you want clients to use DHCP to obtain IP addresses from the threat defense.
Procedure
Step 1 Choose Devices > Device Management, and click the Edit ( ) for the device.
Step 2
Choose DHCP > DHCP Server.
Step 3 On the Server page, click Add, and configure the following options:
Configure the DHCP Server
Cisco Firepower 1010 Getting Started Guide
149