Wi-Fi Protected Setup (Wps) - Epson SureColor P8570D Series User Manual

Wi-Fi Direct is enabled, and the Wi-Fi network name (SSID) and password are displayed.
Note: If Wi-Fi Direct is already enabled, the network name (SSID), password, number of connected
devices, and general procedures for setting up other devices are displayed.
4. Use your computer or wireless device to select the Wi-Fi network name (SSID) displayed on the
LCD screen, then enter the password shown.
5. When a connection is established, select Close to finish.
6. Select Close on LCD screen to close the network connection settings screen.
7. Select the
You see the
your computer or device, and then print. If you are printing from a computer, make sure you installed
the network software from the Epson website.
Note: If you don't see the
name or entered the password incorrectly. Repeat these steps to try again.
Any connected devices will be disconnected when you turn off the printer. To reconnect after turning the
printer back on, repeat these steps.
Parent topic:
Related tasks
Accessing the Web Config Utility

Wi-Fi Protected Setup (WPS)

If your network uses a WPS-enabled wireless router or access point, you can quickly connect your
product to the network using Wi-Fi Protected Setup (WPS).
Note: To check if your router is WPS-enabled, look for a button labeled WPS on your router or access
point. If there is no hardware button, there may be a virtual WPS button in the software for the device.
Check your network product documentation for details.
Using WPS to Connect to a Network
Parent topic:
home icon to exit.
icon on the LCD screen and should be able to connect to your product directly from
icon on the LCD screen, you may have selected the wrong network
Wi-Fi Direct Mode Setup
Wi-Fi or Wired Networking
41