Epson SureColor P800 Screen Print Edition User Manual

Screen Print Edition
What's Included
The following items are included with the Screen Print Edition of your product:
®
Epson Screen Positive Film (1 roll)
■
TM
AccuRip Black Pearl SE RIP Software welcome card
■
■ Roll paper holders (SureColor
Setting up your Screen Print printer
Step 1: Set up your printer and load the film
Set up your printer using the directions in the printer's documentation.
Note: Wear gloves while handling the Screen Positive film to avoid getting smudges or
fingerprints on the film.
Loading the Screen Positive film (SureColor T3270)
Load the film roll using the directions for roll paper installation in the online User
Guide.
Loading the Screen Positive film (SureColor P800)
Attach the roll paper unit and load the film roll onto the roll spindle using the
directions in the online User's Guide. Then follow the steps below to load the film into
the printer.
1. Open the front cover of the printer and extend the first section of the output tray.
2. Open the rear support, but do not pull out the extension.
3. On the touch screen, navigate to Setup > System Administration > Printer
Setting and change the Paper Size Check setting to Off.
4. Load the film roll in the roll paper unit with the grey flange on the left-hand side.
5. Feed the film into the printer until it stops, then hold the film in place. Press
Load on the touch screen to pull the film into the printer.
6. Check the touch screen and make sure the Paper Size is correct and that the
Paper Type is set to Premium Luster, then click OK.
®
P800 only)