Panasonic PT-53X54J Service Manual page 68

39. Perform all adjustments for blue (B-SKEW, B-LINEAR, B-SIZE, B-
PIN, B-CORNER, B-KEY)
40. Display border and cross pattern and confirm that blue overlaps
with green pattern, if it is not satisfactory, repeat for blue.
41. Press "1 or 3" key repeatedly on remote until green, red and blue
(white), confirm that red and blue overlaps with green pattern.
42. Press "7" key on remote, then ACTION to save changes.
43. Press POWER then ACTION to exit adjustments or press TV/
VIDEO for at least 3 seconds to change to Fine Adjustment Mode.
44. After exiting COARS adjustment the "AUTO OFFSET" procedure
begins. The receiver performs an horizontal and vertical sweeping
offset reference with the new saved data for autoconvergence
alignment feature (see "autoconvergenceadjustment" for more
information.
18.2. Fine adjustment mode (FINE) (convergence)
NOTE:
It is strongly recommended to first read and understand the following section prior to make any
adjustment.
HELPFUL HINT:
The easiest way to adjust convergence is to start adjusting from the center of the screen to the
borders in all the convergence adjustments.
Once in "FINE" convergence mode press "4" on remote control frequently to change crossed
sections, this helps to check convergence more accurate in more sections of the picture. Please
see the following figuresthat show the cycle, this does not have any effect on the positions of the
cursor.
"FINE" convergence mode default Grid
68