At this point the keyboard, A/V inputs and convergence sensors,
must be disconnected from K-board and G-board, otherwise the
cables and connectors could get damaged.
Screen assembly
1. Remove the screen frame. See screen frame removal procedure
above.
2. Place screen frame face down on a soft surface.
3. If necessary remove G-board and/or K-board.
4. If necessary disassemble A/V panel removing the screws (4) and
tilt the panel upwards and release it from screen frame.
5. Remove the screws from the screen frame (20), be careful not to
damage the convergence sensors (see picture).
6. Carefuly lift screen frame leaving the screen frame cover with the
3 screens (Fresnel, Lenticular, Protective) on top of it.
Keyboard and front A/V inputs removal
1. Unplug the connectors from keyboard and front A/V inputs
assemblies. Remove the screws affixing the keyboard (4 screws)
and front A/V inputs (3 screws) and tilt the A/V panel assembly
Screen assembly (Inside view)
29