Panasonic PT-53X54J Service Manual page 5

3. Important safety tests
Measuring H.V.
The anode caps are cemented to the CRTs. To gain access for high voltage measurement,
remove the red CRT's anode lead from the flyback transformer distributor. Grasp the anode lead
protective cap at its bottom and squeeze it against thelocking cap body inside, rotate 1/4 turn
counter clockwise and pull the anode lead sleeve out of the FBT distributor. Connect a high
voltage positive lead from your H.V. meter to the FBT distributor, and the common negative lead
to cold ground
FBT leads removal
Note:
Reinsert the anode lead into the FBT distributor until it is tightly and fully seated. Turn the
locking cap clockwise to lock in place.
(EHT) Protector operation check
With the cabinet back removed, apply a nominal 120V A.C. to the PTV.
Over voltage test
Preparation:
1. Turn PTV "OFF"
2. Connect a NTSC signal generator to the antenna terminal.
3. Connect DVM positive lead to D31 pin 2 and negative lead to D31
5