NetApp AFF A200 Manual page 41

If you want to run diagnostic
tests on...
Individual components
Then...
a. Clear the status logs:
b. Display the available tests for the selected devices:
device show -dev dev_name
dev_name can be any one of the ports and devices identified in
the preceding step.
c. Examine the output and, if applicable, select only the tests that
you want to run:
sldiag device modify -dev dev_name
-selection only
-selection only disables all other tests that you do not want to run
for the device.
d. Run the selected tests:
After the test is complete, the following message is displayed:
*> <SLDIAG:_ALL_TESTS_COMPLETED>
e. Verify that no tests failed:
dev_name -long -state failed
System-level diagnostics returns you to the prompt if there are no
test failures, or lists the full status of failures resulting from testing
the component.
sldiag device clearstatus
sldiag device run -dev dev_name
sldiag device status -dev
sldiag
39