NetApp AFF A200 Manual page 18

synchronize.
◦ If the command fails because of an NDMP, SnapMirror, or SnapVault process, disable the process. See
the appropriate Documentation Center for more information.
11. Once the giveback completes, check the failover and giveback status with the
and
`storage failover
Only the CFO aggregates (root aggregate and CFO style data aggregates) will be shown.
12. Move the console cable to the target controller.
13. If you are running ONTAP 9.5 and earlier, run the key-manager setup wizard:
a. Start the wizard using the
enter the passphrase for onboard key management when prompted.
b. Enter the
key-manager key show -detail
the onboard key manager and verify that the
If the
c. Wait 10 minutes for the key to synchronize across the cluster.
14. If you are running ONTAP 9.6 or later:
a. Run the
security key-manager onboard sync
prompted.
b. Enter the
security key-manager key query
in the onboard key manager and verify that the
keys.
If the
c. Wait 10 minutes for the key to synchronize across the cluster.
15. Move the console cable to the partner controller.
16. Give back the target controller using the
command.
17. Check the giveback status, 3 minutes after it reports complete, using the
command.
If giveback is not complete after 20 minutes, contact Customer Support.
18. At the clustershell prompt, enter the
interfaces that are not on their home controller and port.
If any interfaces are listed as false, revert those interfaces back to their home port using the
command.
revert
19. Move the console cable to the target controller and run the
versions.
20. Restore automatic giveback if you disabled it by using the
-auto-giveback true
16
show-giveback` commands.
security key-manager setup -nodenodename
column = anything other than yes, contact Customer Support.
Restored
column = anything other than yes/true, contact Customer Support.
Restored
storage failover giveback -fromnode local
net int show -is-home false
command.
command to see a detailed view of all keys stored in
column =
Restored yes
command and then enter the passphrase when
command to see a detailed view of all keys stored
column =
Restored
version -v
storage failover modify -node local
storage failover show
command, and then
for all authentication keys.
for all authentication
yes/true
storage failover show
command to list the logical
net int
command to check the ONTAP