Four-channel CA-COM output
DO
Terminal block output (LA2Xi)
4−
4+
3−
3+
2−
2+
2.5 mm² cables
1−
1+
Cabling 5XT using screw terminals
Accessories
Tools
The procedure is shown with 5XT-SEALPLATE.
5XT-SEALPLATE is an optional accessory, and is sold separately.
Assembly
Prerequisite
• Refer to
APPENDIX: Recommendation for speaker cables
• Refer to
Cabling schemes for 5XT
About this task
5XT-SEALPLATE has two cable glands: one for the input cable and one for the cable connecting to the next enclosure in
parallel. The second cable gland is equipped with a protective plug. This procedure describes how to connect the input
cable to the enclosure. If the enclosure must be connected in parallel, remove the protective plug from the second cable
gland and proceed identically for both cables.
The cable gland only ts cables with a gauge of up to 4 mm².
5XT owner's manual (EN) version 4.0
SPK1
SP
SPK2
SPK3
SPK4
-
+
-
+
5XT-SEALPLATE (optional)
2 M4x30 screws (provided with 5XT-SEALPLATE)
3 mm slotted screwdriver
T20 Torx bit and torque screwdriver (optional)
(p.45).
(p.28).
Connection to LA amplied controller
29