Advertisement
1.
100M copper port
2.
Reset button
3.
Terminal block 1 for power input
4.
Power indicator
5.
Running indicator
6.
Copper port connection indicator
7.
Serial port transmission data indicators
8.
Serial port receiving data indicators
9.
Lugs
10.
RS-485/422/232 DB9 serial port
11.
RS-485/422/232 RJ45 serial port
12.
Grounding screw
13.
Terminal block 2 for power input
14.
Console port
【Mounting Dimension】
Unit: mm
Model I, Model II
Model III, Model IV
Notice Before Mounting:
Don't place or install the device in area near water or
moist, keep the relative humidity of the device
surrounding between 5%~95% without condensation.
Before power on, first confirm the supported power
supply specification to avoid over-voltage damaging the
device.
The device surface temperature is high after running;
please don't directly contact to avoid scalding.
【Wall-mounted Device Mounting】
Model I, Model II
Step 1
On the wall of device mounting, place the device on
the wall for reference or refer to the mounting
dimension to mark two screw positions.
Step 2
Nail M4 screws on the wall and keep 2mm
interspace reserved.
Step 3
Hang the device on two screws and slide
downward, then tighten the screw to enhance
stability, mounting ends.
Model III, Model IV
Step 1
Adopt M3 screw to install the left/right mounting
board on the device backboard.
Step 2
On the wall of device mounting, place the device on
Advertisement
