JVC XV-521BK Service Manual page 7

Removing the DVD mechanism assembly
Prior to performing the following procedure, remove
the top cover and the front panel assembly.
1. Disconnect the card wire from connector CN101 on
the DVD Servo.
2. Disconnect the harness from connector CN031 on
the DVD mechanism assembly.
3. Remove the screw E on the rear left part of the
loading tray.
3. From the front side of the DVD mechanism
assembly, move the lever d in the direction of the
arrow and pull out the loading tray.
4. Remove the two screws F on the upper side of the
DVD mechanism assembly. Then release the two
joints e and detach the clamper base back-upward.
5. Remove the three screws G
mechanism assembly.
(See Fig.11 to 14)
attaching the DVD
Loading tray
E
DVD mechanism assembly
Fig.11
Loading tray
DVD mechanism assembly
Fig.12
DVD mechanism assembly
F
Joint e Clamper base
Fig.13
G
G
DVD mechanism assembly
Fig.14
XV-521BK/523GD/522SL
CN101
DVD Servo
P031
Lever d
P031
CN101
F
Joint e
CN101
G
1-7