Pc Card - Casio IT-2000W Technical Reference Manual

2.3.6 PC Card

Hardware Overview
Standard
Register compatibility
Slot
Power supply
Card lock switch
Recommended PC Cards
Type
SRAM card
ATA Flash ROM card
How to Format SRAM Card and ATA F-ROM Card
To format, call FORMAT.COM in the basic drive (C:). Then, in the DOS prompt screen that
appears, execute the following command to format the SRAM card or ATA F-ROM card.
FORMAT.COM can also be called as a child process.
FORMAT G:
COM Port of Modem Card
COM Port
IRQ
I/O Address
Notes:


This port is not applicable for a 3.3V card, CardBus, or a ZV port.


Neither turn off the power nor remove the card while accessing the card. If this is done, system
operation becomes unstable.


Before using each type of PC card the PC card driver should be installed by means of the
CONFIG.SYS file. For information about the method used to write CONFIG.SYS refer to
Chapter 4.2 "How to Write CONFIG.SYS and AUTOEXEC.BAT".


If the PC card is inserted in the slot and the card is locked, a card recognition sound (buzzer) will
be issued. Since the card is locked, a short period may be required until the recognition sound is
actually issued. Therefore, it is necessary to confirm this recognition sound in advance if
accessing to the card. An error may occur if the card is accessed before the recognition sound is
issued.
Conforms to PCMCIA Release 2.1
Has register compatibility with Intel 82365SL Step
1 slot TYPE II
Vcc : 5V (not operable at 3.3V)
Has a card lock switch
DT-635MC (256 KB)
DT-636MC (512 KB)
DT-637MC ( 1 MB)
DT-9031FMC ( 2.5 MB)
DT-9032FMC ( 5 MB)
DT-9033FMC (10 MB)
DT-9034FMC (20 MB)
COM3
11
3E8h to 3EFh
44
Model