Using A Compactflash Card - Casio Cassiopeia E-100 Getting Started Manual

Using a CompactFlash Card

Your CASSIOPEIA supports Type I and Type II CompactFlash cards (3.3V).
Important
The card slot cover will not close when certain types of cards are in the slot. Remove
the card slot cover and keep it in a safe place so you can replace it when you remove
the card.
Gently but firmly slide the card into place as far as it will go, but do not force it.
Forcing a card can damage connectors. If you have problems inserting a card, pull it
out and check to make sure it is oriented correctly.
We strongly recommend that you store all unsaved data you are inputting or editing
before performing this procedure.
Sometimes, your CASSIOPEIA may not be able to detect a CompactFlash card. This
is indicated when a program on the card does not start up normally. When this
happens, remove the card, reinsert it, and then press the CASSIOPEIA RESET
button.
Your CASSIOPEIA supports 3.3V CompactFlash cards only. 5.0V cards are not
supported.
Use of an IO card that requires large amounts of power can cause the CASSIOPEIA
to restart when CASSIOPEIA battery power is low.
1. Make sure your CASSIOPEIA is turned off.
Press the [Power] button to turn off power.
2. Pressing upward at the point indicated in the illustration, slide the cover up to open it.
Press upward here.
3. If there is already a card in the slot, remove it.
22
Important
Pull the cover out as far as it will
go and then swing it open.