Installation Method - Casio IT-2000W Technical Reference Manual

7.9.4 Installation Method

The method used to install the IrDA driver in Windows is described here. Using WINST.EXE it is
also possible to install it according to the default settings. Use the following information as a
reference for manual installation or if modifying the setup contents.
The Windows3.1 IrDA driver is installed with the following procedure. Assume that this installation
is made in the Windows system, and that installation is made from the card drive (G:) in

D: WINDOWS.


Copy IRDA.DLL and IRCOMM.DRV into D:
> COPY G:
> COPY G:


Copy COMM.DRV into the MASK ROM drive into D:
> COPY E:


Modify the contents of the SYSTEM.INI file as follows:
Modify the following settings in the "boot" section.
(Before modification)
comm.drv=comm.drv
(After modification)
comm.drv=ircomm.drv
Add the following section to the end of the file.
[Ircomm.drv]
comm=RSCOMM.DRV
IrDA=IRDA.DLL
 
IRDA.DLL D: WINDOWS

IRCOMM.DRV D:
 
WINDOWS COMM.DRV D:

WINDOWS or D:

WINDOWS

WINDOWS, then rename it.

WINDOWS
139
 
WINDOWS SYSTEM.

RSCOMM.DRV