Removing The Optional Serial Module - Dell OptiPlex 3000 Thin Client Service Manual

Steps
1. Insert and push the flat-head screwdriver into the slot on the optional module filler to release the optional module filler from
the chassis.
NOTE: Step one is only applicable for new installation or component upgrade. For replacing an existing component,
follow the procedure from step two.
2. Connect the HDMI module cable to the connector on the system board.
3. Insert the HDMI module into the optional module slot on the chassis.
4. Replace the two screws (M3X3) to secure the HDMI module to the chassis.
Next steps
1. Follow the procedure in
2. Install the side cover.

Removing the optional Serial module

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
About this task
The following image indicates the location of the optional Serial module and provides a visual representation of the removal
procedure.
To identify the ports and connectors, see the
after working inside your
before working inside your
system board connectors.
computer.
computer.
Removing and installing components 27