Appendix; Troubleshooting - Siemens Hicom cordless EM Operating Instructions Manual

Siemens hicom cordless em gigaset active operating instructions
Table of Contents

Advertisement

Appendix

Troubleshooting

Before contacting the Service department, you should
attempt to rectify any errors yourself:
Caution:
The battery compartment must not be opened under
any circumstances in an Ex zone.
Error
No display.
is displayed as soon
as you press the talk
key.
No dial tone; no calls
can be made.
No radio connection
possible to base sta-
tion,
is displayed,
for example, but no
incoming or outgoing
calls are possible.
Activation/deactiva-
tion not possible.
Possible cause
Mobile unit not
switched on.
Battery empty.
cordless EM is fully
utilised by other
users.
The mobile unit is
outside the radio
flashes.
range of the base
stations; radio signal
too weak.
The mobile unit is not
registered.
Excessive delay
between synchroni-
sation attempts.
The mobile unit is
blocked.
60
Remedy
Press the On/Off
key.
Recharge the battery
or replace it with a
spare battery.
Try again later.
Move into radio
range, change loca-
tion.
Register mobile unit.
Switch off mobile unit
and switch it back on
again.
Remove the battery
compartment lid,
remove and then
reinsert the batteries,
close the battery
compartment lid.

Advertisement

Table of Contents
loading

Table of Contents